|
Specifications
Models available
RS-6a: 6 channel
RS-12a: 12 channel
RS-18a: 18 channel
RS-24a: 24 channel
Audio Inputs
Type: differentially balanced instrumentation amplifiers with gain set jumpers and selectable input attenuators
Level: jumper selectable gain settings to accommodate nominal input levels from -60 dBm to +10 dBm. Maximum input level: +22 dBm
Impedance: 20K ohms or jumper selected
Headroom: 22 dBm at any level
Line Outputs
Type: actively balanced
Level: adjustable 0 dBm to +10 dBm, maximum output +22 dBm
Impedance: 100 ohms
Distortion: .008% at nominal operating level, 20 Hz to 20 kHz, Pgm,
Aud and Mono outputs signal to noise: 88 dB (or better) below +4dBm with 0 dBv input level, 20 kHz bandwidth, 600 ohm source impedance (line to line) 74 dB (or better) below +4 dBm output with -50 dBv input level, 20 kHz bandwidth, 150 ohm source impedance (mic to line)
Frequency response: +/- .2 dB 20 Hz to 20 kHz
Monitor Sends
Level: 1 volt rms nominal, 10 volts rms maximum, balanced
Headphone Output
Level: 1 volt rms nominal, 10 volts rms maximum into 600 ohm headphone
Distortion: .05% typical, .1% maximum
Impedance: 50 ohms to front panel jack, 330 ohms to prefader (external amp) output
|
|
Cue Output
2 watts rms into 8 ohm speaker
Dimensions
All consoles are 27 inches deep and 9 inches tall
6 channel: 20.75 inches long
12 channel: 32.75 inches long
18 channel: 44.75 inches long
24 channel: 56.75 inches long
Available Accessories
Copy stand
StudioHub+ Harness
Source cables - specify length and type
Spare power supply
Additional clock/timer (rs-18a and
rs-24a models only)
Additional meter (rs-18a and rs-24a models only)
Auxiliary relay
Available Options
Selector logic card
Basic remote interface card
Enhanced remote interface card
Squawk box card
Squawk box speaker
Four source switcher card
DA card
Dual mix-minus board
Four output mix-minus boards
IFB switcher
Colored fader knobs
Warranty
2 years parts and service
Specifications subject to change without notice
|
601 Heron Drive