RS Home Screen

Console Option Cards

Four Source Router Card
Option cardprovides 4x2 balanced stereo routing which can be used bi-directionally .
Enhanced Remote Interface Card
Option card provices relay closures (n.o. and n.c.) for channel on and off states and opto-isolated contacts to control channel lamps and on/off states. Order one per channel as needed.

8 Output DA Mixer
Option card may be connected to any console audio output(s) to distribute signal to multiple sources. Routes one stereo input to four stereo outputs or two stereo inputs to two stere outputs, or one more input to eight stereo outputs. Each output may be jumper programmed as a mono-sum or left or right of either stereo input. The card may also be used to create "mix-minus" feeds for up to three individual hybrids.

Intercom Card
Option card provides amplification for 2-way intercom and talk-back to any combination of four speakers or Radio Systems' consoles.

48V Phantom Power Supply Card
FOR USE IN DIGITAL CONSOLES ONLY
Option card provides 48v DC to phantom power any condensor microphone wired to an analog input of the console (15v DC phantom power is standard in the digital console and does not require the use of this optional board.

IFB Relay Board
Option card is used to interrupt up to 4 audio sends (typically mix- sends) with an IFB input (typically a host or squawk line-level amplified microphone source).

 

Four Output Mix-Minus Kit
FOR USE IN ANALOG CONSOLES ONLY
Option cards are installed in console base to create four jumper programmable outputs for any mix of 6 channels pre or post-fader audio. Two meter driver outputs are also included.

Kit includes one 4 output and one 6 output card (sufficient for 6 channel console.)

Six Input Mix-Minus Boad
FOR USE IN ANALOG CONSOLES ONLY
Use only in conjunction with 4 output mix-minus board kit. Add one card for each additional 6 channels desired to feed "4-Output" Mix. 1 card is required for the 12 channel console, 2 cards for the 18 channel console.

 

Dual A to D Converter Board
This console option board converts two discreet, balanced, line-level analog signals to AES-EBU format outputs. The board may be factory ordered at 32/44.1/48/96 kHZ sample frequency output. Connectors are to the StudioHub+ pin-out format.

Use the on-board programming pins to set analog input levels for +4 or 0dB input level and connect the RJ-45 shields to the circuit board and DC ground. On-board DC connectors are in parallel and may be used to loop power to anotherdevice.

Selector Logic Card
For use in Analog Consoles Only
Option card adds control (button exclusivity and lamp follow) to the 8 switches located to the right of the monitor section.

Dual IFB / Intercom Board
Routes main (headphone or prrogram) audio to up to two guests and interrupts this audio with alternate (host microphone) audio. Controlled by console individual selector buttons or talk-back switch. Two boards, for talk to up to four guests may be used. StudioHub+ / RJ-45 connectivity.
Dual A to D Converter Board
This console option board converts two discreet, balanced, line-level analog signals to AES-EBU format outputs. The board may be factory ordered at 32/44.1/48/96 kHZ sample frequency output. Connectors are to the StudioHub+ pin-out format.

Use the on-board programming pins to set analog input levels for +4 or 0dB input level and connect the RJ-45 shields to the circuit board and DC ground. On-board DC connectors are in parallel and may be used to loop power to anotherdevice.
4 Output Stereo DA
This optional, compact circuit card installs internally in Millenium consoles and may be connected to any stereo audio output to distribute signal to up to four stereo sources.

The card features bridging inputs, low impedance outputs, and independent level adjusts for each output. It features RJ-45 input and output connectors, whose pin-outs are compatible with the StudioHub+ wiring solution.



Detailed View
Documentation
Part #:
DUAL-A/D

 

Mechanical and Solid State Accessory Relays
12-15v DC 4DPT mechanical relay for use with on-air lights and other AC only external devices that must be controlled from muting and channel remote output lines.

Intercom Speaker
Use in conjunction with the intercom card for hands-free talk to a local Radio Systems console.
Detailed View
Part #:
4PDT
Part #: SPEAKER

3-32v DC single pole solid state relay for use with on-air lights and other AC only external devices that must be controlled from muting and channel remote output lines.

Detailed View
Part #:
SPDT
Untitled Document

Radio Systems, Inc. • 601 Heron Drive • Logan Township, NJ 08085 USA • Phone: 856-467-8000 • Fax: 856-467-3044

bluebar